Close

    • Maximum PSI E46 M3 stock DME/ECU S54 turbo kit runs an 11.07@130 1/4 mile on 13 psi of boost and cracks 600 wheel horsepower

      Congratulations to Maximum PSI (and tuner NickG of Technique Tuning fame) on what certainly looks like a very solid stock DME tuned turbo kit offering for the E46 M3 S54 inline-6. At 13 psi on the stock motor internals using the full Maximum PSI exhaust system and 100 octane race gas the turbo kit put down 602 wheel horsepower on a dynojet using SAE correction. That's some seriously nice power with race gas and the stock motor using the factory ECU.


      The 13 psi 602 wheel horsepower setup also resulted in an 11.07@130 mile per hour 1/4 mile pass at ATCO raceway in New Jersey. Video of the pass, video of the dyno, timeslip, and dynograph are below, congrats to all involved for bringing this to market and showing great results doing what many said could not be done.








      This article was originally published in forum thread: Maximum PSI E46 M3 stock DME/ECU S54 turbo kit runs an 11.07@130 1/4 mile on 13 psi of boost and cracks 600 wheel horsepower started by Sticky View original post
      Comments 8 Comments
      1. Tonester's Avatar
        Tonester -
        Impressive!!
      1. Yukohama's Avatar
        Yukohama -
        solid numbers that'd for sure!
      1. Danny///M's Avatar
        Danny///M -
        was this kit fitted with the 6266 or 6466? Thanks

        - Dan
      1. Commanderwiggin's Avatar
        Commanderwiggin -
        6266
      1. dzenno@PTF's Avatar
        dzenno@PTF -
        Great job guys!
      1. TZ04XJR's Avatar
        TZ04XJR -
        Nice!! I bet that baby is a blast to drive..
      1. Danny///M's Avatar
        Danny///M -
        Cant wait to bolt on this kit in the near future!

        - Dan
      1. Tony@VargasTurboTech's Avatar
        Tony@VargasTurboTech -
        Thats bad ass! Nice work