This issue is not just seen on supercharged cars but stock cars as well. We have been speaking about Sal@evolve and here is what he had to say:
Sal believes there is a defect that affects cylinder 5. Gintani in the video mentions an issue with the rods of the back cylinders. Sal believes it is an issue in the head. It may be a combination of these factors but it is worth exploring.
What we do know is stock cars have failed. We do know the oil system does not seem to be up to par especially for motors driven hard. We know bearings are wearing unevenly. We know BMW did change part numbers on some of the bearings. We know BMW is replacing failed motors that have not violated their warranty with no questions asked. This is all strong evidence of a design defect.
Since there does seem to be a problem, will BMW do a recall? The answer is likely not. It is cheaper for BMW to replace the failed motors and simply wait this issue out until all warranties have expired. Redesigning the oil system is not something the BMW M of today will do. With the S54, the bearing defect in the motor was fixed with a recall due to pressure from the internet and the issue being made widely known.
We have evidence in the past that BMW is not perfect and makes mistakes. BMW is interested in profit above all else, that much is certainly clear. The only way for any of the issues with the S65 V8 to be corrected is for the community to pull together and begin documenting these failures. However, most tuners seem to be interested in taking advantage of any motor that fails which happens to be running a competing tune or kit and leveraging this against them instead of getting to the root of the issue.
Gintani has their own solution that we will not delve into further but it will be applied to the BimmerBoost.com M3. The reality of the situation though is to properly address a weak point in the oiling system it should be made a dry sump oil system. Not a cheap solution, but the proper one. Check out the Gintani video below.